CLI: Setup monitor delay

To setup monitor delay in the GaneshBot CLI:

  1. Launch GaneshBot CLI.

    cli-retry-delay-1.png

  2. Input the number corresponding to "Configure Settings", 61 in my case.

    cli-monitor-delay-1.png

  3. First, we can see our current monitor delay, which is 3,000 ms. To change it, input the number corresponding to "Change Monitor Delay", which is 5 in my case.

    cli-monitor-delay-2.PNG

  4. You can now input the new monitor delay you want, in ms (for example: 3800), and press Enter.
  5. Alternatively, you can use the + and - keys to increase and decrease the delays, which will impact both the retry and monitor delays.

That's it! If you would like to change the monitor delay on the GUI, please refer to our GUI category.

Was this article helpful?
0 out of 0 found this helpful